|
| A |
34" |
This distance can be increased several
inches by not fully engaging the locking plates under the
bed and the tailstock. Stability has not been found to
be a problem when this is done. |
| B | 14.5" |
This distance can also be increased about one inch
by not fully engaging the locking plate under the
bed. Stability has not been found to
be a problem when this is done. |
| C | 11.5" |
|
| D | 15" |
30" swing over machine base. |
| E | 13" |
26" swing over turntable |
| F | 8" |
16" swing over bed. |
| G | 20" |
With the stand this gives a minimum spindle height of 44"
and a maximum height of 53".
If necessary a custom stand height can be arranged.
|
| Base footprint |
36" wide by 32" front to back -- if you are short, the second measurement
is a little smaller than that; if you are tall it will be a little
greater. The motor adds about 9" to the left end. Extending
the bed adds about 17" to the right end.
|
| Motor rating |
2 hp, inverter duty
|
| Inverter type |
Cutler-Hammer MVX9000 vector drive, rfi filter is standard,
mounted on stand.
|
| Inverter output |
0 - 130 Hz
|
| Motor speed |
0 - 3705 rpm
|
| Spindle, low range |
0 - 1390 rpm
|
| Spindle, high range |
0 - 2760 rpm
|
| Spindle size |
1 1/4", 8 tpi, #2 Morse taper, drilled through to 3/8"+
|
| Indexing head |
24 position
|
| Remote control |
Full function: Start, Stop, Direction, Speed -- supplied with
magnet so that it can be positioned anywhere convenient.
|
| Accessories included |
3 1/2" faceplate, #2 M/T live center, #2 M/T spur center,
auxiliary bed, two banjos, 12" tool rest.
|
| Stand |
Welded steel construction, 3" square tubing, height adjustable.
|